I am currently finishing up the shop workbench and beginning a series of tool boxes for all the odd ball tools hanging out in various locations in the shop. The workbench needs 4 drawers and since tool box drawers are going to be built the same way I figured it was time to make tool boxes. We have way to many paper boxes and buckets full of tools. In this process I am making a couple of tools to make these builds possible. I am making a micro-router table to try out some ideas for a more capable router table and to make the drawers of the workbench and toolboxers. I intend to use a router lock joint, a locking rabbit, to hold the drawer corners. On the tool boxes the drawers will be about 16" deep and 30" wide. With a wide drawer like this I will use a half inch bottom with some under the drawer stiffeners. For now the box in planning is for six drawer where each is around 3" to 6" deep. I figure on making a dado for the bottom 3/4" up from the bottom of